Description

Metoset™ Extreme Concrete Repair is a 2-component, 100% solids, moisture-tolerant,
high-modulus, epoxy formula repair resin with high structural strength.
This formula is for outdoor or indoor use, and is very versatile. May be applied to slightly
damp surfaces without any preparations. Ensures a seamless repair.
The product packaging is made from a minimum of 30% to 100% recycled material.

Key applications:

• High Traffic Areas
• Vertical & Overhead
• Edge & Corner Repairs
• Joint Sealing & Bonding

As a structural repair & adhesive for:

• Concrete elements • Hard natural stone • Ceramics, bre cement • Mortar, Bricks, Blocks,
Masonry, render etc. • Steel, Iron, Aluminium • Wood

Vertical and overhead repair of:

• Corners and edges • Hole and void lling • Joint arrises • Joint lling and crack sealing:
• Crack lling and sealing.
• Concrete • Hard natural stone • Solid rock
• Hollow and solid masonry • Steel • Wood

Benefits

• Can be used on damp concrete
• Excellent adhesion to the substrate
• Non-sag, also overhead
• High Structural Strength
• Shrinkage-free hardening
• Styrene-free & Solvent Free
• Easy mix ratio A : B = 1 : 1 by volume

Mixing Method

750g : Mix equal amounts of material from the container marked PART A with material from
the container marked PART B (either by weight or volume). Mix the two components
equally and thoroughlly until an even and consistent mix is achieved. There should be an
even colour consistency in the mixed product.
3KG : Remove the hardener ‘dish lid’ to reveal the resin component beneath. Mix the two
components equally and thoroughlly to the correct ratio until an even and consistent mix is
achieved. There should be an even colour consistency in the mixed product.If necessary
the product can be mixed using a slow speed mechanical mixer.

Important : Use a separate spatula to dispense parts A and B to avoid contamination

Application Method

The applications surfaces must be sound, clean and dry and free from oil, grease, rust or
surface water. The ambient temperatures, the material and the surfaces should be between
5ºC-30ºC. Smooth surfaces should be abraded beforehand. Always check substrate quality
e.g. Concrete surfaces must be in excess of 28 days old.
Apply by trowel, spatula or scraper with a minimum thickness of 1mm.
Ensure adhesion takes place while the product is still mobile and tacky.
Components should be supported during curing to prevent slippage.